Restriction: This topic applies only when the AppMaster Builder AddPack has been installed, and applies only to Windows platforms.
- In
Data View Manager, click the data view for which you want to set properties; then click
File >
Open.
- Click the
Properties tab.
- Do one of the following:
- If you want to load IMS source into an
Enterprise Developer COBOL at the same time you load it into your data view, ensure that
Compile in COBOL Project
is checked on the AppMaster Builder Preferences page.
Note: The COBOL project you select must be enabled for IMS.
- If you want to load SQL into this data view, set your SQL target from the
SQL Target drop-down list; then check the appropriate check boxes. For information on specific fields and controls, see
Database View / Load/Build Database Views - Properties tab.
- Click
Save/Build.
Note: You can also set properties when you create a new data view.