Upload the Software to the Mainframe

The unzipped ChangeMan Attachment contains two XMIT files. Upload both files from the host folder, in binary format, to sequential datasets with a record length of 80 and a block size of 3120, using the following procedure.

1. On z/OS, allocate the datasets to use as the upload target files. To do this, create a dataset with the same characteristics as the sample job below (or by submitting the job below). If you choose to submit the following job, note the following:
   • hlq is the high level qualifier you choose to use for this dataset.
   • Before submitting, add a job card and modify the parameters to meet your site's requirements.
   • Optionally, add a valid VOLSER and/or change the UNIT parameter.

   //ALLOC1 EXEC PGM=IEFBR14
   //*
   //FTPALLOC DD DSN=hlq.CMG.EXEC.XMIT,
   // DISP=NEW,CATLG,DELETE),
   // DSORG=PS,
   // RECFM=FB,
   // LRECL=80,
   // BLKSIZE=3120,
   //* VOL=SER=vvvvvv,
   // UNIT=SYSALLDA,
   // SPACE=(TRK,(45,15))

2. To upload the files, you can use FTP from a command prompt.

   In the sample shown below, commands or other information entered by a user are displayed in bold, and the values in the following table are assumed:

   User input	Description
   mvsaddr	The TCP/IP address or hostname of the z/OS system.
   tsouid	Your TSO user ID.
   tsopw	Your TSO password.
   hlq	High-level qualifier used for the dataset allocated in the job above.

   C:\>ftp mvsaddr
   Connected to mvsaddr.
   220-FTPD1 IBM FTP CS V1R10 at custom.com, 12:03:32 on 2011-08-02.
   220 Connection will close if idle for more than 5 minutes.
   User (mvsaddr:(none)): tsouid
   331 Send password please.
   Password: tsopw
   230 tsouid is logged on. Working directory is "tsouid.".
   ftp> cd ..
   250 " " is the working directory name prefix.
   ftp> cd hlq
   250 "hlq." is the working directory name prefix.
   ftp> binary
   200 Representation type is Image
   ftp> put d:\host\hlq.CMG.EXEC.XMIT
   200 Port request OK.
   125 Storing data set hlq.CMG.EXEC.XMIT
   250 Transfer completed successfully.

   Executing this procedure transfers the following files to your mainframe system:

   • HLQ.CMG.EXEC.XMIT
   • HLQ.CMG.XML.XMIT